12 января 2017 г. 0:13:39 CET, Mini Trader <[email protected]> пишет: >Is it possible for me to add inputs into the interface config for my >adapters. > >I use a utility to restrict uplink speed called wondershaper. > >Normally my /etc/network/interfaces has something like: > >up /sbin/wondershaper eth0 X Y > >Would like to do the same if possible in the zone config. > >On Wed, Jan 11, 2017 at 1:56 PM Dan McDonald <[email protected]> wrote: > >> >> >> > On Jan 11, 2017, at 5:04 AM, Andy Fiddaman <[email protected]> >wrote: >> >> > >> >> > Will we still be able to to configure the networking under zonecfg? >> >> >> >> Yes. >> >> >> >> > Basically what I'm asking is can we stop our zones from being able >to >> change >> >> > their IP address? >> >> >> >> That's a different question, and the answer is going to be no going >> forward, as it is no today. >> >> >> >> I have LX zones using zonecfg(1M) to set DHCP. I can go in as >root@lx-zone >> and use /native/sbin/{ifconfig,route} to take it over. I don't know >off >> the top of my head if SmartOS restricts things this way, but OmniOS >does >> not. >> >> >> >> Dan >> >> >> >> _______________________________________________ >> >> OmniOS-discuss mailing list >> >> [email protected] >> >> http://lists.omniti.com/mailman/listinfo/omnios-discuss >> >>
I am not sure about a direct answer here, but you probably can fiddle with dladm, flowadm, etc. on the illumos host side to limit the capabilities of the vnic you delegate into the zone. -- Typos courtesy of K-9 Mail on my Samsung Android _______________________________________________ OmniOS-discuss mailing list [email protected] http://lists.omniti.com/mailman/listinfo/omnios-discuss
