On 11/3/2011 18:32, Terry wrote:
Memory settings have been discussed on oooforum.org and on the new
community forum. A search should turn up suggested settings; I have
seen it mentioned several times. I think you may have to experiment.
This is one post on the new forum:
http://user.services.openoffice.org/en/forum/viewtopic.php?f=9&t=32090#p146893
Two things seem clear. First, reduce the number of undo steps (the
default, I recall, is 100) to, say 21. Secondly, increase the size
of the graphics cache to, say, 128 MB. Open Office does seem to be a
memory hog; it certainly places a strain at times on my system and
Andrew Pitonyak has mentioned that the odt version of his macro
document causes OO to crash. I have seen reference to "memory
leaking" but don't know what that means.
Terry
FYI: http://en.wikipedia.org/wiki/Memory_leak --/tj/
----- Original Message -----
From: Martin Hediger<[email protected]> To:
[email protected] Cc: Sent: Thursday, 3 November 2011
10:07 PM Subject: Re: Calc Table Display Errors
Hi The sheet is 31K in size. It only contains entries down to row
around 150 and columns to Z, around 50 URLs are in some cells, as
well as around 50 URLs to PDFs on my hard drive. I was thinking,
could it be that I'm not assigning the correct amount of memory?
This can be adjusted in the settings, i saw, but I cant find values
that help. I think I started to have this problem only once i
turned *off* anti-aliasing of fonts, because Openoffice Impress was
having trouble handling a large A0 poster.
Any ideas are very welcomed. Martin
Am 02.11.11 23:39, schrieb Terry:
That sounds like a system problem rather than a software issue.
Try
copying two sheets to a new file, then close all files and exit the
software. Then open the new file only and see whether the problem
occurs in the new file. It may be that you are placing too great a
load on your system.
Terry
----- Original Message -----
From: Martin Hediger<[email protected]> To:
[email protected] Cc: Sent: Thursday, 3 November
2011 3:24 AM Subject: Calc Table Display Errors
Dear List I have a Calc spreadsheet open where a number of
tables are used. However, it becomes hardly unusable, because
when I switch between two
tables
(using the tabs at the bottom of the windom), the values from
the "new" table are printed on top of the "old" values.
It becomes unreadable.
Also often when scrolling, values get "smeared" out all over
the
table. Its as if the value is printed to a new position but not
removed
from the
previous one.
What can be the reason for this? Any suggestions for how to
address
this problem
is very appreciated. I'm working with Mac OS X 10.5.8 and OO
3.3.0 on a MBP.
Thanks for reading Martin <snip>
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
