On 5/27/06, josephhenryblack <[EMAIL PROTECTED]> wrote:
Timothy Miller wrote: > Check out the first revision of the OGD1 PCB artwork: > > http://www.traversaltech.com/OGD1_index.html > > The layers provided are only the routing layers. The power and ground > planes are not provided, due to technical difficulties, but they're > not as interesting anyway. > > Also, I'll have a RevG of the schematic up this weekend. looks good! Can you please remind us what plugs/connectors are on this board? -I was looking to document this on the wiki quickly going through the BOM on the wiki we have
1x S Video Connector (top left?)
Middle left
1x DVI-I Connector (bottom left?)
2x top and bottom left
1x PCI Edge Connector (base) 1x 100 Pin IDC Connector (right) is that a jtag in there..bottom middle?
I'm not sure how the two FPGAs are programmed, exactly. The smaller one is flash-based and probably has a jtag interface for a cable. The bigger one programs itself using an SPI PROM. There is a set of jumpers that connects the small FPGA to the big FPGA's SPI prom so that we can install the jumpers and program that PROM.
A power connector along top toward the right?
Yup.
how much am i missing? how much have i confused<g>
I think you got it.
The ECP2 is smack in the middle -cant miss that one. hmm should print it out and have look at later. I was about to do some pin outs for the ecp2 but can wait for the latest schematic
Many of them are power and ground.
Also can we get pdf only showing the board, the component outlines and their references/names - it would look good on the wiki page for OGD1
It was a pain to produce these images. I'll ask Howard, but that won't be quick. _______________________________________________ Open-graphics mailing list [email protected] http://lists.duskglow.com/mailman/listinfo/open-graphics List service provided by Duskglow Consulting, LLC (www.duskglow.com)
