Ok, I've finished putting in all of the pins (I overwrote the file mentioned below). What I would like verified is (a) that I have gotten the right signals assigned to the ECP2, and (b) that the signals are grouped properly according to the memory chips on pages 7 and 8 of the schematic.
Note the resistors on page 9 for the name changes from M to MEM for some pins. Also, most of the ECP2 memory pins are on page 5, but a handful are near the lower left corner of page 4. On 6/13/06, Timothy Miller <[EMAIL PROTECTED]> wrote:
I've started cataloguing the pins for the ECP2. I'm starting with memory. I've done two pairs of chips, with two to go. What I would like to ask for help with are two things: 1) Finishing the memory section (for now). 2) Checking to make sure I got them right. I'm actually going to keep working on this myself. If anyone wants to help, just post your changes to the list. You can have openoffice spit pieces of spreadsheet out in CSV format, which I can then paste into place, and if there are corrections, just explain them. Here's where you can find the memory pinout: www.traversaltech.com/ogd1_images/ogd1_memory_pins.ods And here's the schematic: http://www.traversaltech.com/ogd1_images/OGD1_RevG.pdf I think everything we need is on page 5. I've just been going through the pins and filling them in on the spreadsheet. I'm not sure how the schematic development process works, but apparently, this is the best format for this information. Thanks!
_______________________________________________ Open-graphics mailing list [email protected] http://lists.duskglow.com/mailman/listinfo/open-graphics List service provided by Duskglow Consulting, LLC (www.duskglow.com)
