I think the $30 might have been a "top end" estimate on the part AND total fab cost. You have to overshoot for a variety of reasons. Given the prices you mention, I don't see why we couldn't toss one into the box. But then I don't know all there is to know, so don't take this as any sort of promise. :)
On 4/18/08, Dieter <[EMAIL PROTECTED]> wrote: > In message <[EMAIL PROTECTED]>, "Timothy Normand Miller" writes: > > Howard said: > > > > Its a 3M part no. P50E-100P1-SR1-EA. > > $5 to $10 from Newark Electronics depending > > on quantity. > > > > The dual row pin strip mentioned in the forwarded > > e-mail wont work because of the staggered pin layout. > > Single row strip (up to 25 pins) works but you cant > > get them to fit in adjacent rows, so you can only > > connect to 50 of the I/O. > > > Prices from Newark web site 2008-04-18 > 1 - 9 $8.70 > ... > 100 - 249 $6.88 > 250 + $6.60 > > right angle version: > > P50E-100P1-SR1-TG > > 1 - 9 $8.74 > ... > 100 - 249 $6.92 > 250 + $6.63 > > Oddly 3M's search can't find these part numbers. > Google the part number, go to the Newark link, > and it has a link for the 3M datasheet. > The datasheet has a drawing with dimensions. > > Looks like it uses half-pitch ribbon cable > rather than the standard. > _______________________________________________ > Open-graphics mailing list > [email protected] > http://lists.duskglow.com/mailman/listinfo/open-graphics > List service provided by Duskglow Consulting, LLC (www.duskglow.com) > -- Timothy Normand Miller http://www.cse.ohio-state.edu/~millerti Open Graphics Project _______________________________________________ Open-graphics mailing list [email protected] http://lists.duskglow.com/mailman/listinfo/open-graphics List service provided by Duskglow Consulting, LLC (www.duskglow.com)
