Obviously, there are dual link DVI receiver chip sets. However, the ones I've used in the past are incompatible with the transmitter footprint. I don't know of any receiver chip that could be fitted in the place of the transmitters we've used.
2009/8/16 Timothy Normand Miller <[email protected]>: > I don't think a DVI receiver would be pin-compatible with a DVI > transmitter. I'll ask Howard about this, but I'm expecting that to do > it, you'd need a daughter board. And in that case, you might as well > make it connect to the hirose connector on the back of OGD1. > > 2009/8/16 "Ing. Daniel Rozsnyó" <[email protected]>: >> I have a short question: >> >> Is it possible to populate one of the two DVI heads with complementary >> chips - I mean with pin-compatible receivers ? Does anybody know if such >> chips exists? >> >> Daniel >> _______________________________________________ >> Open-graphics mailing list >> [email protected] >> http://lists.duskglow.com/mailman/listinfo/open-graphics >> List service provided by Duskglow Consulting, LLC (www.duskglow.com) >> > > > > -- > Timothy Normand Miller > http://www.cse.ohio-state.edu/~millerti > Open Graphics Project > _______________________________________________ > Open-graphics mailing list > [email protected] > http://lists.duskglow.com/mailman/listinfo/open-graphics > List service provided by Duskglow Consulting, LLC (www.duskglow.com) > _______________________________________________ Open-graphics mailing list [email protected] http://lists.duskglow.com/mailman/listinfo/open-graphics List service provided by Duskglow Consulting, LLC (www.duskglow.com)
