Here's what I got by doing that. 
scsi_transport_iscsi: version magic '2.6.18-rc3DH4 mod_unload K7 REGPARM
gcc-4.0' should be '2.6.18-rc3DH4 SMP mod_unload PENTIUM4 gcc-4.0'
libiscsi: version magic '2.6.18-rc3DH4 mod_unload K7 REGPARM gcc-4.0'
should be '2.6.18-rc3DH4 SMP mod_unload PENTIUM4 gcc-4.0'
iscsi_tcp: version magic '2.6.18-rc3DH4 mod_unload K7 REGPARM gcc-4.0'
should be '2.6.18-rc3DH4 SMP mod_unload PENTIUM4 gcc-4.0'
[EMAIL PROTECTED] ~]#



-----Original Message-----
From: open-iscsi@googlegroups.com [mailto:[EMAIL PROTECTED]
On Behalf Of Erez Zilber
Sent: Monday, February 04, 2008 10:29 PM
To: open-iscsi@googlegroups.com
Subject: Re: Error inserting scsi_transport_iscsi


[EMAIL PROTECTED] wrote:

> Hi all,
> I have a issue with the modules failing .
>
> I have the set of Server I use for testing purposes.
> 1x is DELL 2600
> 1x is Supermicro
> 1x Primergy workstaion
> The Dell and supermicro install fine ,b ut i have issues with the
> primergy server.
> I use same steps on my other two computers and it works, but now since
> i have done to the third host.
> When i start the open-iscsi daemon i get the following message below.
> anyone got any ideas?
>
> [EMAIL PROTECTED] open-iscsi-2.0-730]# /etc/init.d/open-iscsi start
> Starting iSCSI initiator service: WARNING: Error inserting
> scsi_transport_iscsi (/lib/modules/2.6.18-rc3DH4/kernel/drivers/scsi/
> scsi_transport_iscsi.ko): Invalid module format
> WARNING: Error inserting libiscsi (/lib/modules/2.6.18-rc3DH4/kernel/
> drivers/scsi/libiscsi.ko): Invalid module format
> FATAL: Error inserting iscsi_tcp (/lib/modules/2.6.18-rc3DH4/kernel/
> drivers/scsi/iscsi_tcp.ko): Invalid module format
>  
> [  OK  ]
> Setting up iSCSI targets: iscsiadm: can not connect to iSCSI daemon!
> iscsiadm: exiting due to configuration error
>  
> [  OK  ]
> [EMAIL PROTECTED] open-iscsi-2.0-730]#

Run 'dmesg -c' before starting open-iscsi. Then, start open-iscsi, run
again 'dmesg -c' and send its output.

Also, you're trying to run on a strange setup - kernel 2.6.18-rc3 (which
is old and is a RC instead of GA) and an old version of open-iscsi. Is
it on purpose?

Erez




--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups 
"open-iscsi" group.
To post to this group, send email to open-iscsi@googlegroups.com
To unsubscribe from this group, send email to [EMAIL PROTECTED]
For more options, visit this group at http://groups.google.com/group/open-iscsi
-~----------~----~----~----~------~----~------~--~---

Reply via email to