What I am seeing in dmesg is this

scsi4 : iSCSI Initiator over TCP/IP
scsi5 : iSCSI Initiator over TCP/IP
scsi6 : iSCSI Initiator over TCP/IP
scsi7 : iSCSI Initiator over TCP/IP
scsi8 : iSCSI Initiator over TCP/IP
scsi9 : iSCSI Initiator over TCP/IP
scsi10 : iSCSI Initiator over TCP/IP
scsi11 : iSCSI Initiator over TCP/IP
scsi12 : iSCSI Initiator over TCP/IP
scsi13 : iSCSI Initiator over TCP/IP
scsi14 : iSCSI Initiator over TCP/IP
scsi15 : iSCSI Initiator over TCP/IP
scsi16 : iSCSI Initiator over TCP/IP
scsi17 : iSCSI Initiator over TCP/IP


On Apr 8, 10:02 am, "Andrew Moise" <[EMAIL PROTECTED]> wrote:
> On Tue, Apr 8, 2008 at 11:51 AM, fischerman <[EMAIL PROTECTED]> wrote:
> >  I have installed the open-iscsi and I can see my sessions just fine.
> >  I can log into the sessions just fine.
>
> >  I am wondering how to mount this device to be used?  I have read the
> >  read-me until I was blue in the face and also I have read the
> >  discussions I was able to search on.
>
>   When you log into the session, you should see messages in dmesg
> indicating that the kernel is aware of new SCSI disks corresponding to
> your iSCSI volumes.  On my system, they look like this:
>
> scsi1 : iSCSI Initiator over TCP/IP
>   Vendor: DELL      Model: MD3000i           Rev: 0670
>   Type:   Direct-Access                      ANSI SCSI revision: 05
> SCSI device sdd: 2787115008 512-byte hdwr sectors (1427003 MB)
> sdd: Write Protect is off
> sdd: Mode Sense: 77 00 10 08
> SCSI device sdd: drive cache: write back w/ FUA
> SCSI device sdd: 2787115008 512-byte hdwr sectors (1427003 MB)
> sdd: Write Protect is off
> sdd: Mode Sense: 77 00 10 08
> SCSI device sdd: drive cache: write back w/ FUA
>  sdd: sdd1
> sd 1:0:0:1: Attached scsi disk sdd
>
>   Once the new devices show up, you should be able to access them just
> like other SCSI volumes; make a partition table (or LVM or whatever
> you prefer), make a filesystem, and mount them.
>   Cheers.  Hope this helps.
--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups 
"open-iscsi" group.
To post to this group, send email to open-iscsi@googlegroups.com
To unsubscribe from this group, send email to [EMAIL PROTECTED]
For more options, visit this group at http://groups.google.com/group/open-iscsi
-~----------~----~----~----~------~----~------~--~---

Reply via email to