Murray wrote:
While modinfo reports that bnx2i is the iscsi driver for this card, /
var/log/messages reports otherwise.
What seems to happen is that the system attempts to load the bnx2i
module, fails and then falls back to bnx2. This was when I had forced
eth1 to use bnx2i via /etc/modprobe.conf :
Mar 8 17:51:37 ndsfdh1 kernel: iscsi: registered transport (bnx2i)
Mar 8 17:52:48 ndsfdh1 kernel: bnx2: eth1: using MSI
Mar 8 17:52:48 ndsfdh1 kernel: bnx2i: iSCSI not supported, dev=eth1
Mar 8 17:52:50 ndsfdh1 kernel: bnx2i: iSCSI not supported, dev=eth1
Perhaps a silly question: do you have the "key" so that the Broadcom's
firmware does accelerated iSCSI?
--
You received this message because you are subscribed to the Google Groups
"open-iscsi" group.
To post to this group, send email to [email protected].
To unsubscribe from this group, send email to
[email protected].
For more options, visit this group at
http://groups.google.com/group/open-iscsi?hl=en.
