On 07/18/2014 07:19 PM, [email protected] wrote: > Hi folks- > > Quick question. Not strictly an openiscsi question but related enough > that I'm hoping someone will help me out. We have installed Ubuntu > 14.04 to an iSCSI target called "rbd_base". We then shut down the > client, cloned the installation, and set up a new target called > "rbd00". I can boot off the clone, however, as the OS comes up I see it > is still attaching to the original target: > > iscsistart: Logging into rbd_base 10.0.0.3:3260,1 > > I assume this is just hard coded into a file somewhere when we did the > original installation, and I can resolve it by changing that file, but > so far I cannot find it. Can anyone point me in the right direction? >
Boot is distro specific. They have implemented it in different ways. If you are using the iscsi ibft feature then the iscsi tools normally just read the ibft info from the system and use that. So if you configured different iscsi targets in the bios setup screens, then we should be getting that info. Check that /sys/firmware/ibft is reporting the correct info. If you are using some sort of net/pxe boot for the initial initramfs/kernel, then it is really distro specific how they tied things together. Does your distro use dracut? If so, check out that info in google. When using dracut, then you can pass the target info on the kernel command line (so check maybe the grub.cfg or grub.conf) and I think it supports dhcp iscsi boot options, so check that those are getting updated properly if you used that. -- You received this message because you are subscribed to the Google Groups "open-iscsi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/open-iscsi. For more options, visit https://groups.google.com/d/optout.
