If you are using be2iscsi, then you would not use ibft. If you are using
a custom boot script then you need be2iscsi and iscsi_boot_sysfs only.
If you are using a distro boot script then it might be more general and
loading ibft (loading ibft loads iscsi_boot_sysfs) because other drivers
need it.

I think for be2iscsi boot, there is no code to get the vlan id and then
pass that down to the driver. However, I think be2iscsi might store the
vlan info in firmware like it does with the other net info. So as long
as the vlan id did not change then you are ok. Jay, is that correct?



On 09/15/2014 12:34 PM, Rob Roschewsk wrote:
> be2iscsi .... but I've made more progress since this post ... see:
> https://groups.google.com/d/msg/open-iscsi/JZVK8BBImg0/QS08QsAwX_wJ
> 
> The configuration of the VLAN still seems to be automagic .... but it's
> working .... 
> 
> 
> On Monday, September 15, 2014 5:23:25 PM UTC, Mike Christie wrote:
> 
>     On 09/11/2014 10:43 AM, Rob Roschewsk wrote:
>     > Hi all ... I've searched but have found no answers .... maybe my
>     > google-juice is low ...
>     >
>     > I need to be able to pass a VLAN ID and enable VLAN TAGGING in
>     iscsistart
>     >
>     > I'm using an EMULEX 10G NETWORK / ISCSI HBA and our iscsi traffic
>     is on
>     > a specific vlan
>     >
>     > Emulex Corporation OneConnect 10Gb NIC (be3) (rev 01)
>     >
> 
>     Are you using the Emulex iscsi offload driver (be2iscsi) or using
>     software iscsi (iscsi_tcp) over the Emulex network driver (be2net)?
> 
> -- 
> You received this message because you are subscribed to the Google
> Groups "open-iscsi" group.
> To unsubscribe from this group and stop receiving emails from it, send
> an email to open-iscsi+unsubscr...@googlegroups.com
> <mailto:open-iscsi+unsubscr...@googlegroups.com>.
> To post to this group, send email to open-iscsi@googlegroups.com
> <mailto:open-iscsi@googlegroups.com>.
> Visit this group at http://groups.google.com/group/open-iscsi.
> For more options, visit https://groups.google.com/d/optout.

-- 
You received this message because you are subscribed to the Google Groups 
"open-iscsi" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to open-iscsi+unsubscr...@googlegroups.com.
To post to this group, send email to open-iscsi@googlegroups.com.
Visit this group at http://groups.google.com/group/open-iscsi.
For more options, visit https://groups.google.com/d/optout.

Reply via email to