Thank you for your advice Dan.
I using multiple rings on different VLAN interfaces.
It has different network address.
Best Regards,
(2011/02/23 6:00), Steven Dake wrote:
> On 02/22/2011 12:09 PM, dan clark wrote:
>> Is it valid for the corosync config to use the same multicast IP/PORT
>> for two different rings? What is the recommended practice (same
>> multicast different ports, or different multicasts same port)?
>>>> interface {
>>>> ringnumber: 0
>>>> bindnetaddr: AAA.BBB.xxx.0
>>>> mcastaddr: 226.94.1.1
>>>> mcastport: 5405
>>>> }
>>>> interface {
>>>> ringnumber: 1
>>>> bindnetaddr: AAA.BBB.yyy.0
>>>> mcastaddr: 226.94.1.1
>>>> mcastport: 5405
>>>> }
>>
>>
>>
>
> Thanks for pointing that out Dan. If using multiple rings on the *same*
> network, make sure they use different multicast addresses.
>
> Regards
> -steve
>
>> _______________________________________________
>> Openais mailing list
>> [email protected]
>> https://lists.linux-foundation.org/mailman/listinfo/openais
>
> _______________________________________________
> Openais mailing list
> [email protected]
> https://lists.linux-foundation.org/mailman/listinfo/openais
>
--
NAKAHIRA Kazutomo
Infrastructure Software Technology Unit
NTT Open Source Software Center
_______________________________________________
Openais mailing list
[email protected]
https://lists.linux-foundation.org/mailman/listinfo/openais
