Good day list
We acquired a BS-11 microBTS a while ago and in the preliminary stages
of setting up the equipment came upon the following:
background -
1. we installed OpenBSC as per the OpenBSC wiki.
2. we manufactured a serial cable to interact with the BS-11.
3. using bs11_config as per the bs11_config wiki page we started the
BS-11 and got the following:
$ ./bs11_config -p /dev/ttyUSB0
bs11_config (C) 2009 by Harald Welte and Dieter Spaar
This is FREE SOFTWARE with ABSOLUTELY NO WARRANTY
LMT LOGON: ACK
PHASE: 1 Warm Up Abis-link: Down
PHASE: 1 Warm Up Abis-link: Down
PHASE: 1 Warm Up Abis-link: Down
.
.
PHASE: 1 Warm Up Abis-link: Down
PHASE: 1 Software required Abis-link: Down
No valid safety Load file "BTSBMC76.SWI"
After this nothing further happens.
From the wiki page I conclude that the file in question is the SMU safety load
that is needed to create the minimal configuration to get the BS-11 to boot.
There seem to be another firmware image needed for the BS-11 namely the
HS011106.SWL
Am I correct in my assumption that the BS-11 was not preloaded with this
software?
Where do I get these firmware images as the wiki page states that the project
can't provide any of the firmware due to copyright constraints.
Regards
--
Paul van Wyk
_____________________________________________________
TruTeq Wireless (Pty) Ltd. Tel +27 12 667 1530
http://www.truteq.com Fax +27 12 667 1531
Copyright & Legal: http://truteq.com/legal_notice.pdf
