Hi everyone,

I'm currently struggling with getting the NITB example (https://osmocom.org/projects/cellular-infrastructure/wiki/Osmocom_Network_In_The_Box) running.

My problem looks as follows: I do see messages reaching the HNBGW component but whenever the HNBGW tries to reach the SGSN component I get the following error:

DLSS7 <000c> osmo_ss7_hmrt.c:278 m3ua_hmdc_rx_from_l2(): dpc=188=0.23.4 not local, message is for routing
DLSS7 <000c> osmo_ss7_hmrt.c:258 MTP-TRANSFER.req for DPC 188: no route!

Using the VTY interface I can see that only HNBGW and MSC annouced their code points towards STP. :

as-rkm-1     AS_ACTIVE    1          0.23.5

as-rkm-2     AS_ACTIVE    2          0.23.1

However, I can not see the code point 0.23.4 (SGSN). In addition, I'm also not sure if the routes are valid as they are:

7.255.7                    0 as-rkm-1            ?       ? ?

7.255.7                    0 as-rkm-2            ?       ? ?

Here are my configurations (without the logging parts):

################### osmo-hnbgw.cfg ###################

cs7 instance 0
 # HNBGW's local point code
 point-code 0.23.5
 # Address book entries, used below
 sccp-address my_msc
  point-code 0.23.1
 sccp-address my_sgsn
  point-code 0.23.4

hnbgw
 iucs
  remote-addr my_msc
 iups
  remote-addr my_sgsn
 iuh
  local-ip 10.1.1.1
  hnbap-allow-tmsi 1


################### osmo-sgsn.cfg ###################

sgsn
 gtp local-ip 10.1.1.1
 ggsn 0 remote-ip 10.1.1.2
 ggsn 0 gtp-version 1
 !auth-policy accept-all
 auth-policy remote
 gsup remote-ip 127.0.0.1
 gsup remote-port 4222

ns
 timer tns-block 3
 timer tns-block-retries 3
 timer tns-reset 3
 timer tns-reset-retries 3
 timer tns-test 30
 timer tns-alive 3
 timer tns-alive-retries 10
 encapsulation udp local-ip 127.0.0.1
 encapsulation udp local-port 23000
 encapsulation framerelay-gre enabled 0

bssgp





################### osmo-hnbgw.cfg ###################

network
 network country code 901
 mobile network code 98
 short name OsmoMSC
 long name OsmoMSC
 encryption a5 0
 rrlp mode none
 mm info 1

msc
 mgw remote-ip 10.1.1.2
 mgw endpoint-range 1 32




################### osmo-stp.cfg ###################

cs7 instance 0
 xua rkm routing-key-allocation dynamic-permitted
 listen m3ua 2905
  accept-asp-connections dynamic-permitted



I hope someone can spot my mistake!

Best regards,

Lars

Reply via email to