Dear Osmocom Community, I have noticed that the wiki page for OpenBSC GPRS at https://osmocom.org/projects/cellular-infrastructure/wiki/OpenBSC_GPRS has not been updated for four years, and since then, there have been significant updates to the software. As a result, the information on the GPRS/EDGE Setup page may be outdated, and I am struggling to configure GPRS on my system.
I have attached my configuration files below for your review.
ip address
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group
default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: enp0s31f6: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc fq_codel
state DOWN group default qlen 1000
link/ether ec:8e:b5:41:cb:90 brd ff:ff:ff:ff:ff:ff
3: wlp1s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state
UP group default qlen 1000
link/ether b8:8a:60:4f:59:02 brd ff:ff:ff:ff:ff:ff
inet 192.168.1.109/24 brd 192.168.1.255 scope global dynamic
noprefixroute wlp1s0
valid_lft 7152sec preferred_lft 7152sec
inet6 fe80::649b:2ab5:6dd3:8779/64 scope link noprefixroute
valid_lft forever preferred_lft forever
osmo-bsc.cfg
Description: Binary data
osmo-pcu.cfg
Description: Binary data
osmo-ggsn.cfg
Description: Binary data
osmo-msc.cfg
Description: Binary data
osmo-sgsn.cfg
Description: Binary data
tun.network
Description: Binary data
wired.network
Description: Binary data
osmo-bts-trx.cfg
Description: Binary data
