The Reflex 72 does something wrong in its PCSC driver as far as I can
remember. Either way, I know that it does not work in OCF. I have
confirmed that before.
Tom
Darryl Collins <[EMAIL PROTECTED]> wrote in message
002001bfa270$cb740b40$[EMAIL PROTECTED]">news:002001bfa270$cb740b40$[EMAIL PROTECTED]...
> Ashish
>
> I am using a Schlumberger Cyblerflex Access card with a Reflex 72 Reader.
I
> may have had
> similar problems to you. I was finding that I was getting PC/SC error
> 00000079 returned
> whenever I accessed the card using anthing other than the Cyberflex
toolkit.
>
> This was the case using either my OCF code (over the top of the
> Pcsc10CardTerminal)
> or using Schlumberger's own TestResMan code. The problem disappeared if I
> used the
> cyberflex toolkit to power the card up prior to using the other tools.
>
> I eventually found that by using TestResMan to connect to the card using
> only T0 protocol (instead
> of T0 | T1), I could sometimes connect to the card successfully.
>
> So, as a temporary measure, I have modified my copy of Pcsc10CardTerminal
to
> try only T0
> connections and provided a loop in my connect code to retry connections up
> to ten times or until
> I get a successful connection. I can now always (?) establish connections
> to the card within a couple
> of seconds. While this is considerably better than not being able to work
> with the card, I am
> looking for a better solution.
>
> I have mailed Schlumberger regarding the problem and had an initial
> response. I believe that they are
> looking at the problem.
>
> Has anyone else any further ideas? My total experience with JavaCard (and
> SmartCards in general)
> is now a grand total of three weeks, so any further feedback would be
> appreciated.
>
> > When I ran this program it did not come out. I used here waitFor()
> > method.
>
> I am using getSmartCard(CardTerminalEvent ctEvent, CardRequest req)
>
> > Do I need to change the opencard.properties file to run it ?
>
> I have only had to specify the card terminal (and the CardServiceFactory,
> ofcourse):
>
>
OpenCard.terminals=com.ibm.opencard.terminal.pcsc10.Pcsc10CardTerminalFactor
> y
>
>
> Hope this helps.
> Darryl
>
>
---
> Visit the OpenCard web site at http://www.opencard.org/ for more
> information on OpenCard---binaries, source code, documents.
> This list is being archived at http://www.opencard.org/archive/opencard/
! To unsubscribe from the [EMAIL PROTECTED] mailing list send an email
! to
! [EMAIL PROTECTED]
! containing the word
! unsubscribe
! in the body.
