Select("vectorlist", 0)
David
I'm attempting to use the pick module to feed a point into the Grid
module to use as the point about which a local grid is built (I then map
a vector field onto the grid output and run it into Glyph). I'm using
Extract to pull out the position component from the output of Pick,
however this gives me a vector list (with a single vector) and Grid
requires a bare vector. Is there any way to strip off that outer pair
of 'brackets'? I can't seem to get Compute to do this. Suggestions?
Thanks!
Neil
--
.............................................................................
David L. Thompson Visualization and Imagery Solutions, Inc.
mailto:[EMAIL PROTECTED] 5515 Skyway Drive, Missoula, MT 59804
Phone : (406)257-8530
