Thanks for all the response.
I forgot to add in the original message that the Rubbersheet scale is set
to 1.0. The regular grid is x, y with z as the data (all z's are
positive). The points are read in with x, y as position and z as the data
value. These points most likely do not coincide with any nodes of the
regular grid.
Gerry Cheok
At 02:43 PM 1/17/2003 -0500, you wrote:
Rubbersheet makes up a reasonable scale. Open the module and set scale to 1.0.
On Friday, January 17, 2003, at 02:03 PM, Geraldine Cheok wrote:
Hello,
I am importing a regular grid into DX which goes to Rubbersheet. At the
same time, I am importing a set of points (separate file) which goes to
Autoglyph. I collect the output from both to Image. In the image, the
points are supposed to lie on the surface but the image shows the points
below the surface. Is there a different scaling for Rubbersheet and the
points and if so, how can I set the scaling so that both have the same scale?
Thanks for any advice in advance.
Gerry Cheok
Chris Pelkie
Vice President
Conceptual Reality Presentations, Inc.
30 West Meadow Drive
Ithaca, NY 14850
