Am Donnerstag, dem 19.09.2024 um 21:56 +0100 schrieb Richard Purdie: > On Thu, 2024-09-19 at 14:06 +0200, Enrico Jörns wrote: > > This adds support for the barebox bootloader (and tools) to oe-core. > > > > In order to have proper testing, this extends oe-selftest to allow > > basic testing of bootloaders. While at it, cover both u-boot and > > barebox. > > > > v7: > > * add missing HOMEPAGE to barebox recipe > > * ignore barebox for maintainers check since the recipe is skipped > > during parsing (because of PREFERRED_PROVIDER mechanism). > > > > Enrico Jorns (5): > > barebox: set default BAREBOX_CONFIG for qemu machines > > oeqa/utils/qemurunner: support ignoring vt100 escape sequences > > oeqa: support passing custom boot patterns to runqemu > > oeqa/selftest/cases: add basic u-boot test > > oeqa/selftest/cases: add basic barebox tests > > > > Marco Felsch (2): > > barebox: add initial support > > barebox-tools: add initial barebox tools support > > This looked better in testing, thanks. There was: > > https://valkyrie.yoctoproject.org/#/builders/23/builds/168/steps/14/logs/stdio > > which is from oe-selftest on an ARM server though :/
Thank you for the test log! I'll try to figure out why it works in my test setup but doesn't in the autobuilder.. Not sure if I'll have the chance to reproduce it on an ARM host. Barebox doesn't seem to boot at all (or output is missing) and U-Boot got stuck. U-Boot log in the failed test says > U-Boot 2024.07 (Jul 01 2024 - 18:07:18 +0000) > DRAM: 256 MiB > Core: 51 devices, 14 uclasses, devicetree: board > Flash: 64 MiB > Loading Environment from Flash... *** Warning - bad CRC, using default > environment > In: serial,usbkbd > Out: serial,vidconsole > Err: serial,vidconsole > Bus xhci_pci: Register 8001040 NbrPorts 8 > Starting the controller While my successful run goes further: > [...] > Starting the controller > USB XHCI 1.00 > scanning bus xhci_pci for devices... 3 USB Device(s) found > Net: eth0: virtio-net#32 > ESC[?25h > Hit any key to stop autoboot: 2 But not sure if this is an issue with USB emulation or something else... Regards, Enrico > Cheers, > > Richard > -- Pengutronix e.K. | Enrico Jörns | Embedded Linux Consulting & Support | https://www.pengutronix.de/ | Steuerwalder Str. 21 | Phone: +49-5121-206917-180 | 31137 Hildesheim, Germany | Fax: +49-5121-206917-9 |
-=-=-=-=-=-=-=-=-=-=-=- Links: You receive all messages sent to this group. View/Reply Online (#204735): https://lists.openembedded.org/g/openembedded-core/message/204735 Mute This Topic: https://lists.openembedded.org/mt/108538165/21656 Group Owner: [email protected] Unsubscribe: https://lists.openembedded.org/g/openembedded-core/unsub [[email protected]] -=-=-=-=-=-=-=-=-=-=-=-
