Hi Bruce, On Aug 29, 2013, at 4:35 PM, Bruce Ashfield <[email protected]> wrote:
> With that, it's always been a manual setup for me in the past. The typical > workflow is to test them via the usermode NFS boot. Have you given > that a go ? Does yocto have some wrapper script/command to setup nfs boot automatically without too much manual configuration? The runqemu and runqemu-internal scripts seems to indicate that, but haven't tried this before. Let me know if it exists! If not, if you could point me to a link that describes how to set NFS boot, and use it to load a beagleboard image it would be great! > Once I'm over the 3.10 introduction curve, I'm happy to dust off my > old A9 support and get the right qemu support for a full system boot. That sounds good. We should aim for adding support for both A8 and A9, since that represent the current bulk of last-gen and current-gen platforms out there. Best regards, Elvis Dowson _______________________________________________ Openembedded-core mailing list [email protected] http://lists.openembedded.org/mailman/listinfo/openembedded-core
