Hi KK, Not for inband control. This is related with the inband implementation of the reference code. As far as I know Indigo runs into the same issues, cc'ing Dan in case he was any workaround.
I use two workarounds for dhcp on the wan link : - use out-of-band - create a virtual interface (which also acts as NAT), and then have physical in-band but logically out-of-band,. Thanks, Y. On Mon, May 16, 2011 at 3:11 PM, kk yap <[email protected]> wrote: > This is Openwrt specific. From the Pantou wiki page, "Due to the way > inband control is implemented you won't be able to route dns and dhcp > requests/replies from/to the local-port (tap0).". Thus, I wonder if > there is other ways to get a dynamic address on the interface. Hoping > that Yiannis would know. > > Regards > KK > > On 16 May 2011 15:08, Rob Sherwood <[email protected]> wrote: > > I'm not really sure what you're asking: `dhclient tap0` doesn't do the > > right thing for you? Or, are you asking for the interface to come up > > at boot time? > > > > - Rob > > . > > > > > > > > On Mon, May 16, 2011 at 3:06 PM, kk yap <[email protected]> wrote: > >> Hi, > >> > >> I need to control to a remote controller and therefore need to config > >> an IP address for the AP on tap0. Can I config tap0 to receive a > >> dynamic IP address? If yes, how? > >> > >> Thanks. > >> > >> Regards > >> KK > >> _______________________________________________ > >> openflow-discuss mailing list > >> [email protected] > >> https://mailman.stanford.edu/mailman/listinfo/openflow-discuss > >> > > > _______________________________________________ > openflow-discuss mailing list > [email protected] > https://mailman.stanford.edu/mailman/listinfo/openflow-discuss >
_______________________________________________ openflow-discuss mailing list [email protected] https://mailman.stanford.edu/mailman/listinfo/openflow-discuss
