Hi Troy, As Murphy says this can be done. Have you started POX already in your setup? Perhaps FlowVisor is crashing because the port 6633 is already used by POX.
Also what version of FlowVisor are you using? It seems from the error message that you are using an old version. The latest version should have clearer error messages. Cheers. -- Ali On Mar 8, 2013, at 9:55 AM, Murphy McCauley <murphy.mccau...@gmail.com> wrote: > Yes, this can be done. > > On Mar 8, 2013, at 12:38 AM, Troy Loop wrote: > >> I installed Pox, flowvisor and mininet on my laptop. >> I just want to create the >> virtual openflow networks with mininet and then >> connected the switches to the >> Flowvisor, also, I want to connect the pox >> controllers to the flowvisor. > > ... all seems fine so far ... > >> troy@troy-Rev-1-0:~$ /usr/local/sbin/flowvisor > > Are you following along with the guide? > https://github.com/OPENNETWORKINGLAB/flowvisor/wiki/Installation-from-Source > > It looks like you're not executing flowvisor as root, where the guide > specifically shows it being run with sudo. > > -- Murphy > _______________________________________________ > openflow-discuss mailing list > openflow-discuss@lists.stanford.edu > https://mailman.stanford.edu/mailman/listinfo/openflow-discuss _______________________________________________ openflow-discuss mailing list openflow-discuss@lists.stanford.edu https://mailman.stanford.edu/mailman/listinfo/openflow-discuss
