I was able to load the kernel modules but unable to configure the interface ib0 with /sbin/ifup
Is /sbin/ifup the correct command to setup the infinband interface or is there any other procedure to follow ?
I tried also to configure "manually" the interface but pinging another node does not work.
I execute the following commands :
# modprobe ib_mthca # modprobe ib_ipoib # lsmod Module Size Used by ib_ipoib 51608 1 ib_sa 12812 1 ib_ipoib ib_mthca 76944 0 ib_mad 28180 2 ib_sa,ib_mthca ib_core 41472 4 ib_ipoib,ib_sa,ib_mthca,ib_mad iptable_filter 4224 0 ip_tables 19600 1 iptable_filter ep 418080 0 rms 24868 0 elan4 256520 1 ep elan3 304400 1 ep elan 41760 3 ep,elan4,elan3 qsnet 91812 5 ep,rms,elan4,elan3,elan # dmesg ib_mthca: Mellanox InfiniBand HCA driver v0.06-pre (November 8, 2004) ib_mthca: Initializing Mellanox Technology MT23108 InfiniHost (0000:04:00.0) divert: not allocating divert_blk for non-ethernet device ib0 divert: not allocating divert_blk for non-ethernet device ib1 ]# ifup ib0 Error, some other host already uses address xxx.yyy.zzz.119.
Thanks for your help Philippe _______________________________________________ openib-general mailing list [EMAIL PROTECTED] http://openib.org/mailman/listinfo/openib-general
To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
