Hi Joe,
If you have a switch with an SM, you can use that one instead of
opensm. This is the configuration I use, but only because was the
simplest way for me to set things up. Others on this list will be able
to help you if you want to use OpenSM.
A real quick test to see if you can communicate is to use ping.
If you built the IB stack as modules, load the IPoIB driver:
modprobe ib_mthca
modprobe ib_ipoib
Regardless of how you compiled the code, ifconfig the ib interfaces
and then try a ping.
james
On Thu, 9 Jun 2005, Joe Damato wrote:
Hello,
I recently started to check out infiniband -- unfortunately I am unable to
find documentation explaining how to use the different tools. Most notably, I
have read lots of things that mention opensm and/or osmtest, but I have been
unable to find documentation that explains how to use these tools, and how to
test an infiniband setup. Any pointers to where more information can be found
would be greatly appreciated. (I have found plenty of lower-level information
regarding the architecture and stuff, right now I am looking for more very
high level information, just so I can try to test out the small IB set up I
have). ifconfig on a test machine shows ib0 and ib1, both with the same ip
address although I have no idea what else needs to be done (more setup
possibly?) or how to test. My apologies for wasting anyone's time, as this
list seems to be mostly development-related and my question does seem
somewhat "trivial" compared to the other traffic on this list.
Thanks for your time,
Joe Damato
_______________________________________________
openib-general mailing list
[email protected]
http://openib.org/mailman/listinfo/openib-general
To unsubscribe, please visit
http://openib.org/mailman/listinfo/openib-general
_______________________________________________
openib-general mailing list
[email protected]
http://openib.org/mailman/listinfo/openib-general
To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
