Hi Amith, On Fri, 2005-08-05 at 15:22, amith rajith mamidala wrote: > We have been testing gen2 installation using the mem-free IBA cards from > Mellanox. We were able to successfully run InfiniBand tests over this > installation. When we replaced the IBA mem-free with the mem cards > (no software changes), the ports are in the disabled state and ibstatus shows > the following: > > Infiniband device 'mthca0' port 1 status: > default gid: fe80:0000:0000:0000:0002:c901:0a31:a431 > base lid: 0x0 > sm lid: 0x0 > state: 1: DOWN > phys state: 3: Disabled > rate: 10 Gb/sec (4X) > > Infiniband device 'mthca0' port 2 status: > default gid: fe80:0000:0000:0000:0002:c901:0a31:a432 > base lid: 0x0 > sm lid: 0x0 > state: 1: DOWN > phys state: 3: Disabled > rate: 10 Gb/sec (4X) > > > We were wondering what was going wrong?
Someone else from OSU reported this issue with the Physical state indicating disabled rather than polling. I'm not sure if/how this was resolved. What is the firmware version of these cards ? Can you run /usr/local/ib/bin/ibstat ? You will need umad for this. -- Hal _______________________________________________ openib-general mailing list [email protected] http://openib.org/mailman/listinfo/openib-general To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
