On 2/8/06, Michael S. Tsirkin <[EMAIL PROTECTED]> wrote: > Quoting r. Michael Di Domenico <[EMAIL PROTECTED]>: > > Subject: Re: openib and mellanox hca problem > > > > On 2/8/06, Michael S. Tsirkin <[EMAIL PROTECTED]> wrote: > > > If you really suspect timing issues, you can always > > > increase timeouts: look for msleep in mthca_reset.c and try bumping up > > > the numbers. > > > > > > Anyway - could you please enable mthca debug in menuconfig? > > > This would give us some more information on whats going on. > > > > I enabled debug in the module config recompiled and tried to reload > > using modprobe ib_mthca and got the same results? Am i missing a > > debug parameter somewhere? Or should it just spit out more > > information automatically? > > Yes, it should spit out things like "Found bridge". > Are you sure you installed it properly? > > To check, you can try to stick mthca_dbg(mdev, "Here\n"); at the beginning of > mthca_reset and see that it gets printed.
definately working... Feb 8 10:01:23 linux14-ts kernel: ib_mthca: Mellanox InfiniBand HCA driver v0.06 (June 23, 2005) Feb 8 10:01:23 linux14-ts kernel: ib_mthca: Initializing 0000:07:00.0 Feb 8 10:01:23 linux14-ts kernel: ACPI: PCI Interrupt 0000:07:00.0[?] -> GSI 26 (level, low) -> IRQ 217 Feb 8 10:01:23 linux14-ts kernel: ib_mthca 0000:07:00.0: Here Feb 8 10:01:23 linux14-ts kernel: ib_mthca 0000:07:00.0: Found bridge: 0000:06:03.0 Feb 8 10:01:34 linux14-ts kernel: ib_mthca 0000:07:00.0: PCI device did not come back after reset, aborting. Feb 8 10:01:34 linux14-ts kernel: ib_mthca 0000:07:00.0: Failed to reset HCA, aborting. Feb 8 10:01:34 linux14-ts kernel: ACPI: PCI interrupt for device 0000:07:00.0 disabled _______________________________________________ openib-general mailing list [email protected] http://openib.org/mailman/listinfo/openib-general To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
