Steve> I assume you mean cxgb3c.ko. This module is needed to
Steve> support multiple ULPs using the cxgb3 device for managing
Steve> TCP connections. The OpenIB driver uses it to allocate and
Steve> setup iWARP LLP connections + pass data in streaming mode
Steve> (for MPA negotiation) before going into RDMA mode and
Steve> associating the LLP stream with a iWARP QP. It is
Steve> separated from the LLD/NETDEV driver because its not needed
Steve> for a dumb NIC only installation. There will be other ULPs
Steve> that use this interface.
Yeah, cxgb3c.ko was what I meant.
I'm not sure the t3c subdirectory under drivers/infiniband/hw is the
sensible place for it given the way it's going to be used, but I guess
that's a secondary issue.
- R.
_______________________________________________
openib-general mailing list
[email protected]
http://openib.org/mailman/listinfo/openib-general
To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
