On Wed, May 07, 2014 at 04:44:42PM +0200, Arnd Bergmann wrote: > On Wednesday 07 May 2014 10:20:56 Jason Cooper wrote: > > > ipmi message handler version 39.2 > > > IPMI System Interface driver. > > > ipmi_si: Adding default-specified kcs state machine > > > ipmi_si: Trying default-specified kcs state machine at i/o address 0xca2, > > > slave address 0x0, irq 0 > > > ipmi_si: Could not set up I/O space > > > Trying to free nonexistent resource <0000000000000ca2-0000000000000ca2> > > > Trying to free nonexistent resource <0000000000000ca3-0000000000000ca3> > > > ipmi_si: Adding default-specified smic state machine > > > ipmi_si: Trying default-specified smic state machine at i/o address > > > 0xca9, slave address 0x0, irq 0 > > > ipmi_si: Could not set up I/O space > > > Trying to free nonexistent resource <0000000000000ca9-0000000000000ca9> > > > Trying to free nonexistent resource <0000000000000caa-0000000000000caa> > > > Trying to free nonexistent resource <0000000000000cab-0000000000000cab> > > > ipmi_si: Adding default-specified bt state machine > > > ipmi_si: Trying default-specified bt state machine at i/o address 0xe4, > > > slave address 0x0, irq 0 > > > ipmi_si: Could not set up I/O space > > > Trying to free nonexistent resource <00000000000000e4-00000000000000e4> > > > Trying to free nonexistent resource <00000000000000e5-00000000000000e5> > > > Trying to free nonexistent resource <00000000000000e6-00000000000000e6> > > > ipmi_si: Unable to find any System Interface(s) > > > Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled > > ... > > > > It appears to be unrelated to the failure this original message was > > about. However, the failure brought the above to our attention. > > > > Is the IPMI driver used on ARM? Documentation/IPMI.txt indicates a > > dependency on ACPI, but that isn't reflected in the Kconfig. At any > > rate, it seems rather unhappy. :( > > It certainly can be used, and it can be probed through a known PC-style > port number or through the DT binding. > > However, we don't normally want it to try the PC style addresses, which > appear to be used in this case. This should only happen if > CONFIG_IPMI_SI_PROBE_DEFAULTS is set, as far as I can tell. Is that > set in your configuration?
It's not set in multi_v7_defconfig, which is the config this failed under. At least not on linux-3.10.y. Kevin, do you still have the full config from this build? Could you send us the IPMI related settings? thx, Jason. ------------------------------------------------------------------------------ Is your legacy SCM system holding you back? Join Perforce May 7 to find out: • 3 signs your SCM is hindering your productivity • Requirements for releasing software faster • Expert tips and advice for migrating your SCM now http://p.sf.net/sfu/perforce _______________________________________________ Openipmi-developer mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/openipmi-developer
