Try to get the device ID repeatedly during initialization before giving up.
The BMC isn't always responsive, and this allows it to be slightly flaky
during early boot.

Tested: Installed on a system with the BMC software disabled
such that it was non-responsive.  The driver correctly detected this
and gave up as expected.  Then I re-enabled the BMC software unloaded
and reloaded the driver and it was detected properly.

Signed-off-by: Patrick Venture <vent...@google.com>
---
v2:
 - removed extra variable that was set but not used.
---
 drivers/char/ipmi/ipmi_si_intf.c | 23 ++++++++++++++++++++++-
 1 file changed, 22 insertions(+), 1 deletion(-)

diff --git a/drivers/char/ipmi/ipmi_si_intf.c b/drivers/char/ipmi/ipmi_si_intf.c
index 90ec010bffbd..5fed96897fe8 100644
--- a/drivers/char/ipmi/ipmi_si_intf.c
+++ b/drivers/char/ipmi/ipmi_si_intf.c
@@ -1918,11 +1918,13 @@ int ipmi_si_add_smi(struct si_sm_io *io)
  * held, primarily to keep smi_num consistent, we only one to do these
  * one at a time.
  */
+#define GET_DEVICE_ID_ATTEMPTS 5
 static int try_smi_init(struct smi_info *new_smi)
 {
        int rv = 0;
        int i;
        char *init_name = NULL;
+       unsigned long sleep_rm;
 
        pr_info(PFX "Trying %s-specified %s state machine at %s address 0x%lx, 
slave address 0x%x, irq %d\n",
                ipmi_addr_src_to_str(new_smi->io.addr_source),
@@ -2003,7 +2005,26 @@ static int try_smi_init(struct smi_info *new_smi)
         * Attempt a get device id command.  If it fails, we probably
         * don't have a BMC here.
         */
-       rv = try_get_dev_id(new_smi);
+       for (i = 0; i < GET_DEVICE_ID_ATTEMPTS; i++) {
+               pr_info(PFX "Attempting to read BMC device ID\n");
+               rv = try_get_dev_id(new_smi);
+               /* If it succeeded, stop trying */
+               if (!rv)
+                       break;
+
+               /* Sleep for ~0.25s before trying again instead of hammering
+                * the BMC.
+                */
+               sleep_rm = msleep_interruptible(250);
+               if (sleep_rm != 0) {
+                       pr_info(PFX "Find BMC interrupted\n");
+                       rv = -EINTR;
+                       goto out_err;
+               }
+       }
+
+       /* If we exited the loop above and rv is non-zero we ran out of tries.
+        */
        if (rv) {
                if (new_smi->io.addr_source)
                        dev_err(new_smi->io.dev,
-- 
2.19.0.rc2.392.g5ba43deb5a-goog



_______________________________________________
Openipmi-developer mailing list
Openipmi-developer@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/openipmi-developer

Reply via email to