On 26 Sep 2012, at 22:36, Quanah Gibson-Mount wrote: > --On Wednesday, September 26, 2012 11:59 AM +0100 Mark Cairney > <[email protected]> wrote: > >> My olcDB values are listed below (minus the olcDbConfig entries). I'm not >> sure if you need the indexes but I've left them in anyway: >> > >> olcDbCacheFree: 1 >> olcDbCacheSize: 400000 >> olcDbIDLcacheSize: 1200000 > >> set_cachesize 4 0 1 > > This may be a little small. I prefer to fully cache my DB.
Which one in particular? I thought the set_cachesize had an upper limit of 4GB but your guidance on the Zimbra website suggests this is an old limit and I now can't find the page on the OpenLDAP site which discusses it. Alternatively would increasing the number of caches from 2 to 2 or 3 be a suitable workaround? Given that I've got a relatively healthy amount of RAM available would the following sound sensible to you olcDbCacheSize: 1000000 olcDbIDLcacheSize: 1200000 set_cachesize 4 0 2 I also want to give a bit of headroom for new user accounts (approx rate of increase 80,000/y) and creating a group object for each user. > > >> I'm not using an SHM key (should I be?). > > So with 300,000 users, your caches look fine. I would definitely recommend > using an SHM key if you are going to stick with using BDB. I personally > prefer using MDB with current RE24 these days. It is magnitudes faster than > BDB in all aspects if you enable write map. I've looked at your guidance on using SHM keys but I'm slightly reluctant to start playing around with kernel settings on production servers :-) The existing default settings on RHEL 5 seem massive in comparison though: kernel.shmmax = 68719476736 kernel.shmall = 4294967296 Whereas based on the ZImbra performance tuning page I calculated (based on 8GB BDB cache size + 0.5GB for other stuff) shmall would be: 2228224 and shmmax: 8589934592 Both of which appear to be an order of magnitude smaller than the defaults! Then there appears to be some Zimbra-specific commands but I'm guessing the equivalent is just setting the olcDBShmKey in slapd.d on vanilla OpenLDAP? My plan in the longer term is to move to MDB but when I tried it out on one of our test VMs (40GB HD) it pretty much devoured all available disk space. Is there a rule of thumb for deriving probable MDB disk space requirements based on existing BDB size? Thanks for the help and apologies for all the additional questions! Kind regards, Mark -- The University of Edinburgh is a charitable body, registered in Scotland, with registration number SC005336.
