Helo, thanks for your tips. I tried it and here are my resultst step by step.
> $ 1) Reboot the computer. Yes, I did. > $ 2) check dmesg output "dmesg | tail -30" and you should see some messages > about finding USB devices. Yes, there are some messages. Here is the output of "dmesg | tail -30 | grep usb": [EMAIL PROTECTED]:~$ dmesg | tail -30 | grep usb [ 49.735491] usb 2-2: USB disconnect, address 4 [ 49.975376] usb 2-2: new low speed USB device using uhci_hcd and address 5 [ 50.152854] usb 2-2: configuration #1 chosen from 1 choice [ 50.176758] drivers/usb/input/ati_remote.c: Weird data, len=1 ff 00 00 00 00 00 ... [ 288.284000] usb 2-2: USB disconnect, address 5 [ 288.528000] usb 2-2: new low speed USB device using uhci_hcd and address 6 [ 288.704000] usb 2-2: configuration #1 chosen from 1 choice [ 288.732000] drivers/usb/input/ati_remote.c: Weird data, len=1 ff 00 00 00 00 00 ... > $ 3) do the modprobe, create /dev/gadget, and mount it. Done this without errors. > $ 4) run QEMU The same as every try before. [EMAIL PROTECTED]:~$ cd /home/myuser/openmoko/qemu-neo1973 && ./arm-softmmu/qemu-system-arm -M neo -m 130 -mtdblock openmoko/openmoko-flash.image -kernel openmoko/openmoko-kernel.bin -usb -usbgadget -show-cursor -localtime -usbdevice keyboard Could not configure '/dev/rtc' to have a 1024 Hz timer. This is not a fatal error, but for better emulation accuracy either use a 2.6 host Linux kernel or type 'echo 1024 > /proc/sys/dev/rtc/max-user-freq' as root. Warning: could not find USB gadgetfs neo_gsm_switch: GSM disabled. pcf_write: charging in Qualification Mode. pcf_write: charge voltage 4.20V. neo_lcd_rst_switch: LCD reset. jbt6k74_command: Display on. neo_vib_switch: Buzz, buzz. neo_vib_switch: Vibrator stopped. neo_bl_switch: LCD Backlight now on. s3c_timers_write: Bad register 0x40 neo_bl_intensity: LCD Backlight now at 20/64. jbt6k74_command: Display on. s3c_adc_write: Bad register 0x8 s3c_mmci_write: Bad register 0x38 > # 5) use Ctl+Alt+2 to switch to QEMU Monitor > # 6) "info usbslave" should display that device 1 is the CDC Network Yes, it is. > # 7) "usb_add gadget:1" This should work silently in the monitor and NOT > display an error message on the QEMU stream output to the desktop. It displays the following Error: Could not add USB device ´gadget:1´ The same as before. And of course it's because qemu doesn't find the gadgetfs > # 8) Ctl+Alt+1 to switch back to normal QEMU display > $ 9) use ifconfig to set the usb0 device parameters This isn't posible because there is no interface. I've done all things I known I've to do to get it working but it doesn't work. Do you know why that seems to be so difficult? Do you known what I could do else? Or may it be a problem of Ubuntu? (I don't think but maybe it is?) -- Kind regards, Ingmar Rieger [EMAIL PROTECTED]
