Hi!
I've recently updated to openocd head. I am getting this strange message in
the output, when I am connecting to the target, and performing a reset.
Also, the processor does not brake at main().
I used the same gdb script for a while now, and it was working flawlessly.
Has something changed in openocd? Is my gdb script "not-quite-correct"?
I tried with the one I have been using (I hacked this together some time
ago, without too much knowledge about openocd and gdb, and such, but it was
working, so "if it works don't touch it")
set arm abi AAPCS
target remote localhost:3333
poll
monitor halt
monitor soft_reset_halt
break main
continue
And also I tried with this one:
#set arm abi AAPCS
#target remote localhost:3333
#monitor reset halt
#break main
#continue
They both give the same messages, and neither of them stop at main. If I
insert a breakpoint manually in eclipse, it stops there however.
I am using a kt-link programmer, and an lpc1768 chip, sourcing the config
files from the tcl directory.
Regards,
Ákos Vandra
------------------------------------------------------------------------------
Keep yourself connected to Go Parallel:
INSIGHTS What's next for parallel hardware, programming and related areas?
Interviews and blogs by thought leaders keep you ahead of the curve.
http://goparallel.sourceforge.net
_______________________________________________
OpenOCD-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/openocd-devel
