This is an automated email from Gerrit. Tomas Vanek ([email protected]) just uploaded a new patch set to Gerrit, which you can find at http://openocd.zylin.com/3942
-- gerrit commit cb21b48463fc37387c710fe87f959f7475baaf2a Author: Tomas Vanek <[email protected]> Date: Sat Jan 7 17:04:30 2017 +0100 tcl at91samdXX.cfg: partially revert change 3722 Commit 25d7ba19c9e70cf5b912f660cf6aaa93d9ca120f introduced a problem with 'reset halt' due to setting srst_pulls_trst: Error: cortex_m.c:595 cortex_m_halt(): can't request a halt while in reset if nSRST pulls nTRST Sorry, I don't know why I overlooked it when I tested #3722. Change-Id: I41e9473dd91a86d93cf3e78b1fbbdfe1dd188d83 Reported-by: Ladislav Laska <[email protected]> Signed-off-by: Tomas Vanek <[email protected]> diff --git a/tcl/target/at91samdXX.cfg b/tcl/target/at91samdXX.cfg index 9a3c292..93a95c8 100644 --- a/tcl/target/at91samdXX.cfg +++ b/tcl/target/at91samdXX.cfg @@ -50,7 +50,8 @@ $_TARGETNAME configure -event reset-deassert-post { } # SRST (wired to RESET_N) resets debug circuitry -reset_config srst_gates_jtag srst_pulls_trst +# srst_pulls_trst is not configured here to avoid an error raised in reset halt +reset_config srst_gates_jtag # Do not use a reset button with other SWD adapter than Atmel's EDBG. # DSU usually locks MCU in reset state until you issue a reset command -- ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ OpenOCD-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/openocd-devel
