---
** [tickets:#189] stm32f0 invalid sequence for writing option bytes**
**Status:** new
**Milestone:** 0.9.0
**Created:** Tue Jun 05, 2018 01:17 PM UTC by Dmitry Rezvanov
**Last Updated:** Tue Jun 05, 2018 01:17 PM UTC
**Owner:** nobody
Hello.
I'm working with STM32F030F4P6 in Eclipse. I tried to write option bytes
through OpenOCD and failed.
Cause: For writing option bytes an STM32F030 used STM32F1x flash driver. After
writing, an STM32F1x is necessary only system reset. For STM32F030x is
necessary Power-On-Reset or setting to '1' the OBL_LAUNCH in FLASH_CR(look
RM0360, sheet 65).
---
Sent from sourceforge.net because [email protected] is
subscribed to https://sourceforge.net/p/openocd/tickets/
To unsubscribe from further messages, a project admin can change settings at
https://sourceforge.net/p/openocd/admin/tickets/options. Or, if this is a
mailing list, you can unsubscribe from the mailing list.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
OpenOCD-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/openocd-devel
