We found some issue in .cfg file and fixed the issue. Now we are getting
following,
Warn : Unknown flash1 device id = 0x1a609d
Warn : FSIZE field in QSPI_DCR(1) doesn't match actual capacity.
Warn : Unknown flash1 device id = 0x1a609d
Warn : FSIZE field in QSPI_DCR(1) doesn't match actual capacity.
flash 'stmqspi' found at 0x90000000
Error: illegal protection block range
Warn : Flash driver of stm32h7x.qspi does not support free_driver_priv()
Warn : Unknown flash1 device id = 0x1a609d
Warn : FSIZE field in QSPI_DCR(1) doesn't match actual capacity.
flash 'stmqspi' found at 0x90000000
Error: illegal protection block range
Warn : Flash driver of stm32h7x.qspi does not support free_driver_priv()
Herewith I have attached .cfg and errors for your reference.
Attachments:
-
[Attach.zip](https://sourceforge.net/p/openocd/tickets/_discuss/thread/30610e82af/1b48/attachment/Attach.zip)
(2.3 kB; application/x-zip-compressed)
---
** [tickets:#211] Enable break points on QSPI debugging + OpenOCD**
**Status:** new
**Milestone:** 0.9.0
**Created:** Thu Nov 29, 2018 07:45 AM UTC by shaalik
**Last Updated:** Mon Dec 10, 2018 03:51 PM UTC
**Owner:** nobody
Hi,
We were able to debug from QSPI NOR flash on custom stm32H7 + NOR board, and
possible to do step in and step over. However it is not possible to set or
clear break points on run time. How can we enable the break points on QSPI NOR
flash debugging
---
Sent from sourceforge.net because [email protected] is
subscribed to https://sourceforge.net/p/openocd/tickets/
To unsubscribe from further messages, a project admin can change settings at
https://sourceforge.net/p/openocd/admin/tickets/options. Or, if this is a
mailing list, you can unsubscribe from the mailing list.
_______________________________________________
OpenOCD-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/openocd-devel
