I think that the stellaris configuration is for the on-board ICDI which is
accessible over the board's serial port. I'm experimenting with using an
external one. There are alot of good examples in that folder though. I might
start with the stellaris one, then see what else I can do.
I don't know much about openocd, I'm mainly just experimenting to see what I
can get to work.
Thanks for your help -- this should definitely have been a forum post instead,
I'll followup there if I have any actual questions.
---
** [tickets:#342] invalid command name "hla_layout"**
**Status:** new
**Milestone:** 0.11.0
**Created:** Wed Mar 16, 2022 08:53 PM UTC by Andrew Eidsness
**Last Updated:** Thu Mar 17, 2022 11:27 AM UTC
**Owner:** nobody
I've checked out the v0.11.0 branch and built openocd with the config
parameters listed at the end. I've actually tried several different options,
the one listed at the end is "everything I could find".
I've also reproduced this on the v0.10.0 that comes bundled with my OS (Ubuntu
20.04).
I've connected a FlySwatter2 to a 1294xl, but I get an error when trying to
launch with:
$ openocd -f interface/ftdi/flyswatter2.cfg -f board/ti_ek-tm4c1294xl.cfg -c
init
Open On-Chip Debugger 0.11.0-dirty (2022-03-15-11:17)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
Warn : Interface already configured, ignoring
/usr/local/bin/../share/openocd/scripts/interface/ti-icdi.cfg:11: Error:
invalid command name "hla_layout"
in procedure 'script'
at file "embedded:startup.tcl", line 26
at file "/usr/local/bin/../share/openocd/scripts/board/ti_ek-tm4c1294xl.cfg",
line 7
at file "/usr/local/bin/../share/openocd/scripts/interface/ti-icdi.cfg", line 11
Configuration line:
$ ./configure --enable-dummy --enable-rshim --enable-ftdi --enable-stlink
--enable-ti-icdi --enable-ulink --enable-usb-blaster-2 --enable-ft232r
--enable-vsllink --enable-xds110 --enable-osbdm --enable-opendous --enable-aice
--enable-usbprog --enable-rlink --enable-armjtagew --enable-usb-blaster
--enable-presto --enable-openjtag --enable-jlink --enable-jtag_vpi
--enable-jtag_dpi --enable-amtjtagaccel --enable-bcm2835gpio --enable-imx_gpio
--enable-ep93xx --enable-at91rm9200 --enable-gw16012 --enable-buspirate
--enable-sysfsgpio --enable-xlnx-pcie-xvc --enable-remote-bitbang
---
Sent from sourceforge.net because [email protected] is
subscribed to https://sourceforge.net/p/openocd/tickets/
To unsubscribe from further messages, a project admin can change settings at
https://sourceforge.net/p/openocd/admin/tickets/options. Or, if this is a
mailing list, you can unsubscribe from the mailing list.
