Hi Rick, On Wed, Jan 14, 2009 at 10:09 PM, Rick Altherr <[email protected]> wrote: > > Typically you would create a separate config that sources the interface and > target configs. See the included board configs for examples. In that file, > you would add the jtag_khz line as appropriate. I'm not sure what the > default for JLink is. A value of 0 typically means "use RCLK." If you told > JLink to use RCLK but the target doesn't support it, I'm not sure what would > happen. >
It didn't work. I tested setting jtag_khz but it still not working. I compared output when using axm0432 interface versus jlink output: JLink always stop here: Info : 91 358 arm11.c:1595 arm11_examine(): found ARM1136 Debug: 92 358 arm11.c:1625 arm11_examine(): IDCODE 07b3601d IMPLEMENTOR 41 DIDR 15110004 Debug: 93 364 arm11.c:328 arm11_check_init(): Bringing target into debug mode AXM0432 interface show: Info : 118 485 arm11.c:1595 arm11_examine(): found ARM1136 Debug: 119 485 arm11.c:1625 arm11_examine(): IDCODE 07b3601d IMPLEMENTOR 41 DIDR 15110004 Debug: 120 489 arm11.c:328 arm11_check_init(): Bringing target into debug mode Debug: 121 539 openocd.c:160 handle_init_command(): jtag examine complete Debug: 122 539 openocd.c:166 handle_init_command(): flash init complete Debug: 123 539 openocd.c:170 handle_init_command(): mflash init complete Debug: 124 539 openocd.c:174 handle_init_command(): NAND init complete Debug: 125 539 openocd.c:178 handle_init_command(): pld init complete Debug: 126 539 gdb_server.c:2225 gdb_init(): gdb service for target arm11 at port 3333 Warn : 127 539 tcl_server.c:178 tcl_init(): no tcl port specified, using default port 6666 User : 128 539 command.c:494 command_run_line(): Debug: 129 551 arm11.c:662 arm11_poll(): DSCR 00004002 Debug: 130 662 arm11.c:662 arm11_poll(): DSCR 00004002 Debug: 131 759 arm11.c:662 arm11_poll(): DSCR 00004002 Debug: 132 867 arm11.c:662 arm11_poll(): DSCR 00004002 Debug: 133 975 arm11.c:662 arm11_poll(): DSCR 00004002 Do you some other idea? > -- > Rick Altherr > [email protected] > > "He said he hadn't had a byte in three days. I had a short, so I split it > with him." > -- Unsigned > Best Regards, Alan _______________________________________________ Openocd-development mailing list [email protected] https://lists.berlios.de/mailman/listinfo/openocd-development
