Sure, I have two boards setup this way. Both ARM926 core based. One has two Spansion S29GL parts for a total of 128M NOR flash and another ARM926 based board with two Numonyx M29EW parts with a total of 64M flash.
Regards, Brian On Thu, Jul 16, 2009 at 3:11 PM, Spencer Oliver <[email protected]>wrote: > Hi, > > Before i start diving in, has anyone attempted to use openocd cfi driver > with a similar config: > data nor flash (2x8MB total 16MB - one lower 16bit data, the other upper > 16bit data) connected on a 32bit mcu data bus? > > Some changes will be needed, just wondering if anyone has attempted this. > It is being used on a Sharp (NXP) LH7A404. > > The board is running the apex bootloader that supports this config, just > might be good to add suport to openpcd. > > Cheers > Spen > _______________________________________________ > Openocd-development mailing list > [email protected] > https://lists.berlios.de/mailman/listinfo/openocd-development >
_______________________________________________ Openocd-development mailing list [email protected] https://lists.berlios.de/mailman/listinfo/openocd-development
