On Thu, Sep 10, 2009 at 03:00:27AM +0200, Uwe Hermann wrote: > I recently got a DLP Design DLP-USB1232H UART/SPI/JTAG module which is > based on an FT2232H chip. I originally intended to use it to flash SPI > BIOS chips from various mainboards (for details on that setup see > http://www.coreboot.org/Flashrom/FT2232SPI_Programmer). > > However, this module is equally well usable as JTAG programmer if > connected to the JTAG target properly. I have successfully wired the > module to an Olimex STM32-H103 eval board and flashed a firmware onto > that using OpenOCD using the interface config file attached. > > The nice thing is that everything worked pretty much out of the box, I > didn't have to change a single line of code in the OpenOCD source. > > I documented the details at: > http://randomprojects.org/wiki/DLP-USB1232H_and_OpenOCD_based_JTAG_adapter > > The attached patch adds the respective config file to OpenOCD.
*ping* Can this be committed, or is there a technical problem with the patch? It's successfully tested on hardware here. Uwe. -- http://www.hermann-uwe.de | http://www.holsham-traders.de http://www.crazy-hacks.org | http://www.unmaintained-free-software.org _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
