I didn't strip a "gdb_breakpoint_override hard" I found in mini2440.cfg
as I can see configuration of breakpoints to be legitimate to have in
a board config script.
--
Øyvind Harboe
http://www.zylin.com/zy1000.html
ARM7 ARM9 ARM11 XScale Cortex
JTAG debugger and flash programmer
### Eclipse Workspace Patch 1.0
#P openocd
Index: tcl/target/at91sam3uXX.cfg
===================================================================
--- tcl/target/at91sam3uXX.cfg (revision 2777)
+++ tcl/target/at91sam3uXX.cfg (working copy)
@@ -37,11 +37,6 @@
reset_config srst_only
-# GDB can use this
-gdb_memory_map enable
-# And GDB can flash the chip
-gdb_flash_program enable
-
$_TARGETNAME configure -event gdb-flash-erase-start {
halt
}
Index: tcl/board/mini2440.cfg
===================================================================
--- tcl/board/mini2440.cfg (revision 2777)
+++ tcl/board/mini2440.cfg (working copy)
@@ -123,11 +123,7 @@
# GDB Setup
#-------------------------------------------------------------------------
- gdb_port 3333
- gdb_detach resume
gdb_breakpoint_override hard
- gdb_memory_map enable
- gdb_flash_program enable
#------------------------------------------------
# ARM SPECIFIC
_______________________________________________
Openocd-development mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/openocd-development
