When trying to disassemble the STR912 Comstick (not the stick itself,
just its flash)
with the command
armv4_5 disassemble 0 2048
I get a
"should never reach this point" called at file "command.c", line
469
error.
This is due to the last LOG_ERROR call in the
int arm_evaluate_opcode(uint32_t opcode, uint32_t address,
arm_instruction_t *instruction)
procedure of the file:
.../openocd-0.2.0/src/target/arm_disassembler.c
Is this intended/expected behaviour? What about embedded data???
Also, wouldn't it be nice if the disassembler could:
(it would need to be multi-pass, obviously)
a) insert loop/branch labels eg.
addr_1:
TST R0, 0x01
BNE addr_1
...
B addr_2
...
addr_2:
...
b) name the base register for LDR/STR instructions like
LDR R0, [PC, #0xFC]
LDR R1, [R0, #34]
...
0x5C002000
this should be possible if you have definitions like
.set FMI_NBUF, 0x5C002000
stored in some other file.
Then it could look like
LDR R0, data_1
LDR R1, [SCU, SCU_SCR0]
...
data_1:
0x5C002000 @ SCU
_______________________________________________
Openocd-development mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/openocd-development
