Sure I can provide a log. Here it is, or do you need a logfile with debug
option enabled?
------------------------
Open On-Chip Debugger 0.5.0-dev-00622-g9a04974 (2010-11-30-17:39)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.berlios.de/doc/doxygen/bugs.html
Info : only one transport option; autoselect 'jtag'
5 kHz
adapter_nsrst_delay: 300
jtag_ntrst_delay: 300
trst_and_srst srst_pulls_trst srst_gates_jtag trst_push_pull srst_open_drain
RCLK - adaptive
Info : device: 4 "2232C"
Info : deviceID: 67353336
Info : SerialNumber: FTR5CYBEA
Info : Description: OOCDLink A
Info : RCLK (adaptive clock speed) not supported - fallback to 500 kHz
Info : JTAG tap: lpc2478.cpu tap/device found: 0x4f1f0f0f (mfg: 0x787, part:
0xf1f0, ver: 0x4)
Info : Embedded ICE version 7
Error: EmbeddedICE v7 handling might be broken
Info : lpc2478.cpu: hardware has 2 breakpoint/watchpoint units
Info : accepting 'gdb' connection from 3333
Info : Flash Manufacturer/Device: 0x0001 0x227e
Warn : acknowledgment received, but no packet pending
Info : JTAG tap: lpc2478.cpu tap/device found: 0x4f1f0f0f (mfg: 0x787, part:
0xf1f0, ver: 0x4)
Warn : srst pulls trst - can not reset into halted mode. Issuing halt after
reset.
target state: halted
target halted in ARM state due to debug-request, current mode: Supervisor
cpsr: 0x800000d3 pc: 0x00005238
core state: ARM
Warn : NOTE! DCC downloads have not been enabled, defaulting to slow memory
writes. Type 'help dcc'.
Warn : NOTE! Severe performance degradation without fast memory access
enabled. Type 'help fast'.
requesting target halt and executing a soft reset
target state: halted
target halted in ARM state due to debug-request, current mode: Supervisor
cpsr: 0x800000d3 pc: 0x00000000
Info : Flash Manufacturer/Device: 0x0001 0x227e
flash 'cfi' found at 0x80000000
auto erase enabled
Error: flash write block failed status: 0x0
Error: error writing to flash at address 0x80000000 at offset 0x00000000
(-902)
Command handler execution failed
in procedure 'flash'
------------------------
-----Ursprüngliche Nachricht-----
Von: Øyvind Harboe [mailto:[email protected]]
Gesendet: Dienstag, 30. November 2010 19:10
An: [email protected]
Cc: [email protected]
Betreff: Re: [Openocd-development] Programming external flash with OpenOCD
fails
Could you provide a log?
--
Øyvind Harboe
Can Zylin Consulting help on your project?
US toll free 1-866-980-3434 / International +47 51 63 25 00
http://www.zylin.com/zy1000.html
ARM7 ARM9 ARM11 XScale Cortex
JTAG debugger and flash programmer
_______________________________________________
Openocd-development mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/openocd-development
