An update on this bug.

The bug does does not show up when I change qualify=yes to qualify=no  
in sip.conf

Mark


On Jan 9, 2007, at 11:14 AM, Mark Engelhardt wrote:

>
> On Jan 9, 2007, at 2:39 AM, Jason Garland via List wrote:
>
>> telnet uses TCP and openpbx uses UDP. You would not be able to
>> telnet to it.
>>
>> Type this command to see if openpbx is listening on port 5060:
>> netstat -an|grep 5060
>
> Hum, so I have to amend my bug report. openpbx does seem to be
> listening on 5060, but there is no indication that it is responding
> to traffic.
>
> I have this happening on my laptop right now if anyone can suggest
> some diagnostic tests I might run.
>
> Mark
>>
>>
>> Are these phones behind NAT?
>>
>> - Jason
>>
>>
>> On 1/9/07, Mark Engelhardt via List <mac-telephony-
>> [EMAIL PROTECTED]> wrote:
>>> Hello Everyone,
>>>
>>> I have found what I think is a new bug in OpenPBX PR3
>>>
>>> Tonight, On a mac G4 Xserver running 10.4.8:
>>>
>>> I shutdown asterisk, installed OpenPBX, Copied over my iax.conf,
>>> extensions.conf and sip.conf from my asterisk config,
>>>
>>> then started up openPBX...
>>>
>>> OpenPBX launches fine and them after about 3-4 seconds it stops
>>> registering phones and while the CLI commands work, nothing changes
>>> after that. I did a telnet to port 5060 and it was not open.
>>>
>>> I have seen this same sort of behavior on mac os x with only one  
>>> or 2
>>> phones, but it was not reproducible, it could take from a few hours
>>> to a few days to fail, but with tonight's setup (about 30 phones, it
>>> fails within a few seconds of launch.
>>>
>>> Is this a new bug? How can I help to isolate it? What should I try?
>>> Shall I post this to Trak? Can anyone reproduce this?
>>>
>>> Here are the messages I get:
>>>
>>> OpenPBX Ready.
>>> *CLI>     -- Registered SIP 'matt' at 192.168.21.162 port 52281
>>> expires 60
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer matt
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer marke
>>>      -- Registered SIP 'curt' at 192.168.21.159 port 50302  
>>> expires 60
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer curt
>>>      -- Registered SIP 'hapy' at 192.168.21.156 port 51999  
>>> expires 60
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer hapy
>>>      -- Registered SIP 'joyce' at 192.168.21.230 port 52846
>>> expires 60
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer joyce
>>>      -- Registered SIP 'jaime' at 192.168.21.241 port 50163
>>> expires 60
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer jaime
>>>      -- Registered SIP 'daniel' at 192.168.21.236 port 52782
>>> expires 60
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer daniel
>>>      -- Registered SIP 'Veronica' at 192.168.21.203 port 52015
>>> expires 60
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer Veronica
>>>      -- Registered SIP 'morgan' at 192.168.21.152 port 51506
>>> expires 60
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer morgan
>>>      -- Registered SIP 'rob' at 192.168.21.228 port 51725 expires 60
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer rob
>>>      -- Registered SIP 'jaime' at 192.168.21.241 port 50164
>>> expires 60
>>>      -- Registered SIP 'jon' at 192.168.21.244 port 52861 expires 60
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer jon
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer 576
>>>      -- Registered SIP 'tony' at 192.168.21.248 port 51913  
>>> expires 60
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer tony
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer 575
>>>      -- Registered SIP 'jaime' at 192.168.21.241 port 50165
>>> expires 60
>>>      -- Registered SIP 'WaitsStore2' at 192.168.21.232 port 52648
>>> expires 60
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer WaitsStore2
>>>      -- Saved useragent "Cisco-CP7905/8.0.1-060412A" for peer
>>> ConsultRm2
>>>      -- Registered SIP 'edward' at 192.168.21.240 port 50778
>>> expires 60
>>>      -- Saved useragent "Cisco-CP7960G/8.0" for peer edward
>>> Jan  9 04:10:47 NOTICE[6938]: chan_sip.c:14427 sip_poke_noanswer:
>>> Peer 'marke' is now UNREACHABLE!  Last qualify: 0
>>> Jan  9 04:10:47 NOTICE[6938]: chan_sip.c:14427 sip_poke_noanswer:
>>> Peer '576' is now UNREACHABLE!  Last qualify: 0
>>> Jan  9 04:10:47 NOTICE[6938]: chan_sip.c:14427 sip_poke_noanswer:
>>> Peer '575' is now UNREACHABLE!  Last qualify: 0
>>> Jan  9 04:10:47 NOTICE[6938]: chan_sip.c:14427 sip_poke_noanswer:
>>> Peer 'greg' is now UNREACHABLE!  Last qualify: 0
>>>
>>> After that message, the openpbx cli still works, but something
>>> internal is gone, (like sip show peers never updates)
>>>
>>>
>>>
>>> _______________________________________________
>>> mac-telephony-list mailing list
>>> [EMAIL PROTECTED]
>>> http://lists.mactelephony.net/mailman/listinfo/mac-telephony-list
>>>
>> _______________________________________________
>> mac-telephony-list mailing list
>> [EMAIL PROTECTED]
>> http://lists.mactelephony.net/mailman/listinfo/mac-telephony-list
>
> _______________________________________________
> Openpbx-dev mailing list
> [email protected]
> http://lists.openpbx.org/mailman/listinfo/openpbx-dev

_______________________________________________
Openpbx-dev mailing list
[email protected]
http://lists.openpbx.org/mailman/listinfo/openpbx-dev

Reply via email to