Hi, We are running with OpenSAF 5.2. We have successfully run the following scenarios using TCP:
1) Two SC nodes, configured as active and Standby, use opensafd stop to perform graceful shutdown of active controller, Standby takes over as expected When we reconfigure OpenSAF to use TIPC, we are seeing problems with the Controller failovers. 1) Two SC nodes, use opensafd stop to perform graceful shutdown of active controller, Standby does not take over, eventually the immnd restarts, and we are left in a bad state that requires a node reboot. Is there any information available regarding this behavior, or are there other settings we need to adjust to configure TIPC properly? Additionally, we stepped back to OpenSAF 5.0, and confirmed this same identical behavior. When using TCP, the failover performs as expected. But when configured to use TIPC, this same erratic behavior occurs. Thanks. Jim ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Opensaf-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/opensaf-users
