vinay simha bn writes:
> i used these command to pull the source from ON Mercurial repository by
>
> #hg clone ssh://[EMAIL PROTECTED]/hg/onnv/onnv-gate
I would have done this:
hg init
hg pull ssh://[EMAIL PROTECTED]/hg/onnv/onnv-gate
... but that should do the same.
> it had been 9 hours the shell prompt shows..
It sounds like you're at the end of a very thin straw. Using
the snapshot "bundles" might be another option, if you can find a
faster way to transfer one of those.
> how many hours need to pull the source from ON Mercurial repository.
I don't think any of us are located at your site or know what your
effective Internet bandwidth might be from the repository. However,
the gate (after "pull" and before "update") takes up around 279MB
(just the changesets), and then after "hg update", it's about 656M.
So, however long it takes to pull around 279MB should be the right
answer.
> ..only onnv-gate folder is created in / directory.. it had been 9 hours
> ....there are no files are created in onnv-gate,when files are created in
> this directory.
After pulling the gate, do "hg update".
--
James Carlson, Solaris Networking <[EMAIL PROTECTED]>
Sun Microsystems / 35 Network Drive 71.232W Vox +1 781 442 2084
MS UBUR02-212 / Burlington MA 01803-2757 42.496N Fax +1 781 442 1677
_______________________________________________
opensolaris-code mailing list
[email protected]
http://mail.opensolaris.org/mailman/listinfo/opensolaris-code
