Hello all, I've been trying to get my Dlink (&3com) card w/ Marvell Yukon to come up on 1000fdx on my netgear gige switch. I downloaded the skge driver, and installed the device strings. The driver will come up if I force it to 100fdx, but will not work with autoneg on or if I try to force it 1000fdx.
The switch and cables work perfectly with 2 other gige cards (windoze, linux), so that is not the likely problem. I've installed the skgesol_x64v8.12.1.3 driver, as the 32 bit card syskonnect driver only has 32 bit drivers. My output from port props (i turned off autoneg, otherwise it doesn't work) -bash-3.00# ndd -get /dev/skge port_props Port: A Link Status: Up Link Speed: 100 Mbps Jumbo Frames: No VLAN: No RX Ring Size: 128 TX Ring Size: 128 RLMT Mode: CLS Autonegotiation: No Duplex Mode: Full Flow Control: None Scanpci : pci bus 0x0004 cardnum 0x07 function 0x00: vendor 0x1186 device 0x4c00 D-Link System Inc Gigabit Ethernet Adapter Any thoughts?? Or is there a reliable enet card I can get w/ GigE (PCI). This is brutal, and being an ex-Sun employee of many years I remember why x86 was a PITA. This message posted from opensolaris.org _______________________________________________ opensolaris-discuss mailing list [email protected]
