I've been trying to get OpenSolaris installed on a V100.  I've been using the 
information at :

http://sstallion.blogspot.com/2009/07/installing-opensolaris-200906-on-sparc.html

But given the age of the post, there might not be anybody paying attention.  So 
I'll post my issue here.

But I'm having trouble with the wanboot.  Now, I'm not exactly in a 'basic' 
configuration.  I'm using a Linux box (RHEL based) as my DHCP server, and have 
OpenSolaris installed on a VirtualBox setup as the install server.  (I followed 
the instructions at 
http://dlc.sun.com/osol/docs/content/dev/AIinstall/setup.html, and went the 
advanced route).

Rather than boot from the disk, I have a rarp/tftp setup to serve the wanboot 
image via the net.  So from OBP, I do:

ok boot net -o prompt - install

This goes along fine, and I get to the wanboot prompt.  I setup the host-ip, 
etc just fine and type 'go', and I get the usual startup messages.  It then 
bails with 'network unreachable' (as expected) and I drop into maintenance mode.

Now here is where I am having trouble similar to what JohnR posted on the first 
link.  I try to setup the dmfe0 interface, but DHCP fails.  I see the DHCP 
requests, and my DHCP server responds.  But the interface fails to get 
configured.  I even tried configuring it manually, but nothing.

root:@~# ifconfig -a plumb
root:@~# ifconfig -a
dmfe0: flags=1000842<BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 6
inet 0.0.0.0 netmask 0
ether 0:3:ba:16:85:f3
dmfe1: flags=1000802<BROADCAST,MULTICAST,IPv4> mtu 1500 index 7
inet 0.0.0.0 netmask 0
ether 0:3:ba:16:85:f4
root:@~# ifconfig dmfe0 dhcp

And nothing happens. Looking at my DHCP server, I see the requests and the 
responses. But nothing comes back. From my DHCP log:

Dec 9 16:31:16 wilma dnsmasq[9317]: DHCPDISCOVER(eth0) 00:03:ba:16:85:f3
Dec 9 16:31:16 wilma dnsmasq[9317]: DHCPOFFER(eth0) 192.168.0.60 
00:03:ba:16:85:f3

But on the Sun, nothing. In fact, the status gives:

root@:~# ifconfig dmfe0 dhcp status
Interface State Sent Recv Declined Flags
dmfe0 SELECTING 5 0 0

So, anybody have any ideas?  Or even luck on a V100 or Netra X1?

Thanks!
-- 
This message posted from opensolaris.org
_______________________________________________
opensolaris-help mailing list
[email protected]

Reply via email to