On Mon, Apr 22, 2002 at 02:33:38PM -0700, Haresh Thevathasan wrote:
>
> I have been trying to configure open ssl for hpux.
> I need this in order to run a cgi interface over a secure connection. I am
> rebuilding apache therefore I could potentially "make certificate" and be on
> my way.
> unfortunately when I go to configure openssl (build 0.9.6.c) It looks for a
> perl file in /opt/perl5/lib/5.000
> I checked this in hpux it is located at /opt/perl I created a link between
> perl5 and perl but unfortunately the directories that follow are 5.6.1
> instead of 5.000 is there a better method to setup HPUX 11i to use ssl?
You do have a problem with your perl setup. OpenSSL does not have any
specific version of perl set up (beyond needing Perl5 or later). Especially
it does not have any /opt/perl... paths prepared, as this is a specialty
of the HP-UX Software Porting and Archive Center.
Best regards,
Lutz
--
Lutz Jaenicke [EMAIL PROTECTED]
http://www.aet.TU-Cottbus.DE/personen/jaenicke/
BTU Cottbus, Allgemeine Elektrotechnik
Universitaetsplatz 3-4, D-03044 Cottbus
______________________________________________________________________
OpenSSL Project http://www.openssl.org
Development Mailing List [EMAIL PROTECTED]
Automated List Manager [EMAIL PROTECTED]
