Hello, Until recently we have used an old version of Openssl 0.9.7, but because of the need for support of so called G2 certificates (SHA2) we switched our application to use version 1.0.0.a.
Now we run into a problem when our customers communicate with a certain third party using OpenSSL 1.0.0 the session suddenly gets lost. It looks like the third party disconnected after sending/receiving a lot of messages. Resulting in a read failure on our side of the SSL connection. We also tried most recent version 1.0.0d. The result is regrettably the same. Switching back to good old 0.9.7 it all works again. This third party doesn't need G2 certificates, so in this case this was possible. Our application has been used since long without any change. Using version 0.9.7 no solution however, because most parties being communicated using SSL need the G2 certificates and off course there have been a lot of security fixes since release 0.9.7. What is the best way to clearify what is going wrong ? Kind regards, Heymen Nicolaij Senior Application Designer Software Engineering [cid:[email protected]] E [email protected]<mailto:[email protected]> l M 06 4609 1122 l T 31 (0)40 207 4900 | W www.pinkroccadelocalgovernment.nl<http://www.pinkroccadelocalgovernment.nl/> [cid:[email protected]]<http://www.linkedin.com/groups?mostPopular=&gid=1811286&trk=myg_ugrp_ovr>[cid:[email protected]]<http://www.twitter.com/pinkroccadelg> Disclaimer | The information transmitted is intended only for use by the addressee and may contain confidential and/or privileged material. Any review, retransmission, dissemination or other use of it, or the taking of any action in reliance upon this information by persons and/or entities other than the intended recipient is prohibited. If you received this in error, please inform the sender and/or addressee immediately and delete the material. Thank you. [cid:[email protected]]Please consider the environment before printing this email Kind regards, Heymen
Hello, Until recently we have used an old version of Openssl 0.9.7, but because of the need for support of so called G2 certificates (SHA2) we switched our application to use version 1.0.0.a. Now we run into a problem when our customers communicate with a certain third party using OpenSSL 1.0.0 the session suddenly gets lost. It looks like the third party disconnected after sending/receiving a lot of messages. Resulting in a read failure on our side of the SSL connection. We also tried most recent version 1.0.0d. The result is regrettably the same. Switching back to good old 0.9.7 it all works again. This third party doesn’t need G2 certificates, so in this case this was possible. Our application has been used since long without any change. Using version 0.9.7 no solution however, because most parties being communicated using SSL need the G2 certificates and off course there have been a lot of security fixes since release 0.9.7. What is the best way to clearify what is going wrong ? Kind regards,
E [email protected] l M 06 4609 1122 l T 31 (0)40 207 4900 | W www.pinkroccadelocalgovernment.nl Disclaimer | The information transmitted is intended only for use by the addressee and may contain confidential and/or privileged material. Any review, retransmission, dissemination or other use of it, or the taking of any action in reliance upon this information by persons and/or entities other than the intended recipient is prohibited. If you received this in error, please inform the sender and/or addressee immediately and delete the material. Thank you.
Kind regards, Heymen |
<<inline: image001.jpg>>
<<inline: image002.gif>>
<<inline: image003.gif>>
<<inline: image004.gif>>
