Hi, For Nova-network, You can
ping from vm to vm. ping from vm to internet You can not ping from any host to vm exclude host owned vm You need assign a floating ip to VM. Best regards Yugang LIU Keep It Simple, Stupid On 06/11/2014 08:36 AM, Eric Berg wrote: > Update. I've done a fresh install and am successfully running > instances on my compute host, but, while I can connect out of my > instances just fine, I can't get into them from any host but my > compute host. > > I thought that RDO was going to set me up so that each compute host > handled the routing directly, but it appears that all of my instance's > traffic is routing through a bridge to my control host. > > My compute and control hosts are on a 192.168.0.0/16 network and are > using 192.168.20.0/24 for the instances. > > How do I get traffic routing into my instance hosts on 192.168.20.0/24 > on each compute host? (I only have one now, but will be deploying 2 > more once I have OpenStack set up. > > Eric > > > > On 6/10/14, 4:53 PM, Eric Berg wrote: >> I need some help setting up my network before doing an install of RDO >> using nova-networking. I've got 2 hosts -- one is a control and one >> is a compute host. Each has 2 NICs. >> >> It's my understanding that I need to configure the network before >> doing the install, but I can't find any good docs on just what I have >> to do. >> >> My initial install allowed me to create instances that I could get >> into and out of via ssh, ping, etc., but when I created a new tenant >> and a network for that tenant, the networking stopped working. >> >> I used this command to create the network: >> >> "nova network-create ruby-net --bridge br100 --multi-host T >> --fixed-range-v4 192.168.20.0/24" >> >> While I found more documentation for neutron, I'm not finding much >> for nova. I have the following questions: >> >> 1) how should I set up my network interfaces on the control and >> compute host for a nova-networking installation? >> 2) where are the docs for installation (including such prep as >> above), as well as post-install tenant set-up for this type of network? >> >> Thanks for your consideration. >> >> Eric >> > _______________________________________________ Mailing list: http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack Post to : [email protected] Unsubscribe : http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack
